MkI rear caster (rear strut rod) [Archive] - Toyota MR2 Message Board

rear, caster, strut, alignment, nuts, measurements, machine, factory, rods, hunter, front, stationary, part, mention, adjustment, body, control, assumed, adjustable, assumption, complete, travel, loosen, reaching, lower, tighten, point, rock, pics, attached, references, bushings, imply, ra-43, found, unimportant, laser, aligned, camber, adjusting, cams, adjust, ball, joint, replaced, recently, june, bushing, vehicle, 1987

I have a 1987 (JUNE) AW11. I recently replaced every ball joint and bushing on the vehicle. I have since had it aligned; they used the Hunter laser alignment machine to get the measurements, then did the alignment using the factory camber adjust cams and factory adjusting nuts for toe and caster. The printouts show the difference of before & after. All of the after measurements are either dead center or at least in spec. My questions is this: Why is rear caster never mentioned?