License plate screws rusted, what to use now?? [Archive] - Toyota MR2 Message Board

bolt, holes, plate, screw, bumper, find, i’ve, back, rusted, hole, wouldn’t, screws, doesn’t, solution, guessing, anchor, pull, rear, there’s, work-, it’s, side, https://ibb.co/dgwrb9f, https://i.ibb.co/dgwrb9f/f466-c2-fe-2-dca-4058-89-a7-f6-a10-b168319.jpg, pulling, bigger, ideas, size, registered, tighten, fully, rolling, fell, holding, screwed, bought, seller’s, barely, 1.00, enlarging, work, license, time, spent, night, lowe’s, standard, works

When I bought my car, the screws for the seller’s plate were both rusted and one wouldn’t go back in. The other barely screwed in but wouldn’t fully tighten. I registered car and have been rolling around with just one bolt holding my plate. It fell off sometime last night. I’ve spent time at Lowe’s trying to find a bolt that works. The standard size (I think M6 1.00 x .25??) does not work. I’ve tried enlarging the holes and using a bigger bolt which also doesn’t work- there’s nothing to