3S-GTE USDM Turbo Engine Had ECM out for checking, now car won't start [Archive] - Toyota MR2 Message Board

3S-GTE USDM Turbo Engine, board, damage, caused, meter, connector, check, capacitors, jump, starter, grease, apply, pushed, back, dielectric, suggested, re-installed, delayed, failure, wondering, i&8217m, immediately, fine, narrow, make, guide, troubleshooting, problem, http://manual.teq.org, started, helps, hope, inadvertently, true, burnt, test, blown, checking, start, visually, installed, inducing, unplug, connectors, carefully, anytime, multi, disassembling, pins

After owning a turbo that has been running rich for 3 years, I finally got around to checking the ECM for blown capacitors. Everything looked super clean, so I re-installed and then started the car to make sure everything was OK. It fired up just fine and ran smoothly for a couple of minutes. When I came back a few days later to actually drive it, all dash lights came on as normal when turning the key to the