4A-GE MK1 Engine Compression test after rebuild [Archive] - Toyota MR2 Message Board

4A-GE MK1 Engine, rings, cylinders, compression, test, type, issue, squirting, ring, finish, chrome, verify, seals, sealing, valves, cranking, motor, dave, open, wide, leaking, wall, throttle, miles, seat, alway, stone, number, honing, good, engine, grit, rebuild, shop, machine, depending, cylinder

I just rebuilt my 4AGE engine. It started fine but runs a little rough at idle (which is high). when I rev it the exhaust feels moist. Initially I thought headgasket might be bad. I remember scratching my head trying to figure out which way the Head gasket sat on the block, but one way seemed better than the other (but it was awhile ago when I put it back together). Anyways, I ordered a leak down tester and a device to detect Carbon Monoxide in the coolant. I do have a regular compression