4A-GE MK1 Engine Timing issue [Archive] - Toyota MR2 Message Board

4A-GE MK1 Engine, dizzy, timing, jumped, installed, replace, connect, back, wards, acting, staged, impossible, acts, diagnostic, mode, jump, green, code, blinking, idle, throttle, light, engine, connectors, time, change, check, showing, notch, crank, atmost, vertical, facing, horizontal, rotor, turned, seal, week, issue, finally, dicided, leaking, pull, bearing, seals, test/showed, today, good, spec, heat

Ok, the last week I finally dicided to pull th dizzy to replace the leaking oil seal. I turned the crank until the cam notch was showing atmost vertical and the rotor was horizontal facing right. While I had the dizzy off, it got cleaned, heat shield painted with POR15, both pickup tested (in spec on both) and new seals installed. I did not replace the bearing as it test/showed to be good. Today I installed it and every went well, until I tried to set the timing or I should say until