Coilovers and Flush fitment [Archive] - Toyota MR2 Message Board

clearance, spring, coilovers, coilover, 22mm, .875, half, typical, 3.75, small, amount, 95mm, 63mm, based, vary, 1.75, divid, concern, 51mm, of.125, strut, basically, housing, rate, camber, tire, knuckle, clamp, stock, deeper, necessarily, fitment, flush, make, sits, worse, struts, gain, improve, setup, loose, inside, plates, tilting, suspension

Hey guys I have looked over the wheel fitment guide and have come to finally find a set of wheels that I like and in the width that I like. I am getting a set of BC coilovers and the width of the wheels are a little different. I was hoping you could double check me to make sure that I am going to fit on all four corners. I would like to be as flush as possible for my setup. Here are the measurements of the wheels: Front - 17x8.25 +36mm Rear - 17x9.25 +36mm Thank you for your help and