4A-GE MK1 Engine Oil Filter Bracket Repair [Archive] - Toyota MR2 Message Board

filter bracket, filter sandwich, oil filter bracket, oil filter holder, oil filter repair, 4A-GE MK1 Engine, bracket, exhaust, bolt, compressor, filter, ratchet, socket, manifold, 13mm, outer, lines, shows, removal, bolts, advise, unhooking, mounting, halves, handled, rings, long, 33ftlbs, mating, front, prep, surfaces, large, needed, rear, lousy, 27mm, 96732-31060, “o’s”, remove, removed, seemingly, steel, ring, grunt, rated, wool, bracket/stabilizer, challenged, reading

Oil Filter Bracket “O” Rings Replacement I’m well into my 26th year of ownership, and approximately 400,000 miles, and recently had to deal with failure of the factory “O” ring(s) at the oil filter bracket(s) which is composed of two halves as shown on Page LU-14 of our BGB. (Service Manual) Since my S/C race/street car does not have a compressor my job was made easier not having to drop the compressor. If yours does I’d advise just unhooking the 4 each mounting bolts and moving the